Stainless steel reducers
Stainless conical reductions - offer available at FMIC
Stainless reduction made of the highest quality stainless steel, is excellent for the construction of intake and exhaust systems.
Available reduction diameters are able to meet a wide range of tuning applications, the selection starts from 38mm and ends at 102mm.
Stainless steel reductions are, of course, not the only component needed at the construction stage of the project, so you will also find in the offer:
- Stainless elbows
- Stainless pipes
- Welded stainless elbows
- X-pipe
- Y-pipe
- Stainless rods
- Flanges
The available range makes the construction of exhaust and intake systems in the car much simpler and faster.
Stainless cone reductions - a product of high quality stainless steel, which is widely used in tuning
Reduction is very useful in the construction of exhaust and intake systems (downpipe, TIP, etc.). The wall thickness is 2mm. Depending on delivery, the reduction can come in different heights and be a little lower or higher. Made of austenitic stainless steel 1.4307 / 1.4301 - chromium-nickel steel with low carbon content. The alloy is extremely weldable and has high corrosion resistance.
Technical parameters:
EN: 1.4301 / 1.4307
AISI: 304
Chemical Composition:
C <0,07
Si <1.0
Mn <2.0
P <0,045
N <0,11
Cr 17.50-19.50
Ni 8.00-10.50
Yield strength Re (Rp0.2) min: 230 .
Tensile strength Rm: 540-750
Elongation at break A5 min: 45
HB hardness max: 215
Density at 20°C: 7.9
Modulus of elasticity at 20°C: 200.
Thermal conductivity coefficient: 15
Specific heat at 20°C: 500
Specific resistance: 0.73 .
The large stock of goods in our store makes the delivery of products to the customer in no time. We invite you to check our offer and purchase reductions in case of doubt, our customer service offers information and assistance in tailoring a solution tailored to the customer's expectations. You can contact us by phone, e-mail or chat on the site.