BMW M52, M54 HIGH-PERFORMANCE M12 CYLINDER HEAD STUDS KIT

We now offer superior quality cylinder head studs kit for aluminium M52 or M54 block

Now you will be able to use greater strength when tightening your cylinder head

• 100% CNC machined parts - MADE IN UE
• Special steel developed by FTWL Motorsport Team
• Fits to M52/M54
• It will improve engine reliability
• "MUST HAVE" for all turbocharged BMW engines - drift, drag, racing spec.
• Thanks to our M12 stud set, forged turbobmw engines generate over 700-800 hp+ without any problems
• Probably the best offer on the tuning market
• Often used as a repair set for broken M10 threads - this is much better option than any time-sert etc.
• Compact 16 mm nuts - easy to tighten
• You need to make M12 threads in your engine block
  Use 12.5 mm. drill bit to drill head gasket, head washers (all 14 pcs.) and engine head to 12.5 mm. diameter
• We recommend to use Loctite 3020 to assembly head gasket
• Use grease, torque wrench and tighten all nuts (clockwise) in the following steps:
  1st. step - 40 Nm.       2nd. step - 80 Nm.       3rd. step 110 Nm
• NOTE: DO NOT OVER TIGHTEN THE NUTS. Our product can handle up to ~150 Nm but your engine head wont
• Need a set for your V8 engine? See our other products
• Dont compare our product to some fake reinforced M10 studs made of poor quality materials
• Each product has been quality tested - because our products must handle the highest overload and force...