Roll Over Valve, 10AN ORB to 0.75in Barb Radium Engineering

Manufacturer Radium Engineering
SKU USA-RAD-20-0594

  On demand

 

Roll Over Valve, 10AN ORB to 0.75in Barb Radium Engineering

This fitting should always be mounted in the vertical upright position (shown below). In this condition, air flow is permitted to move through the unit in both directions (in and out). 

However, when the fitting rotates more than 90 degrees, it becomes a shut-off valve not allowing any flow to pass through.

This part was designed to be compatible with Radium Engineering P/N: 18-0042 AIR FILTER, 0.75IN ID. This combination is most commonly used with engine (or oil catch can) vents. It permits venting but prevents oil from escaping the engine if the vehicle is accidentally inverted.

SPECIFICATIONS

Threads: 7/8-14 UNF (10AN ORB)

Barb (OD): 0.75" (19mm)

Material (valve): Stainless Steel

Material (retaining ring): Stainless Steel 

Material (o-ring): FKM

Material (body): 6061 Auminum

Surface (body): Type-II Anodized

More Information

Manufacturer Radium Engineering
Write Your Own Review
You're reviewing: Roll Over Valve, 10AN ORB to 0.75in Barb Radium Engineering
Your Rating:
Loading...

You submitted your review for moderation.

This form is protected by reCAPTCHA - the Google Privacy Policy and Terms of Service apply.